Nilight
1PC Round Rocker Switch with Shell 12V 24V 20A Blue LED Toggle swtich with 16AWG Wires SPST 3Pin 2 Position for Car Truck Vehicle Boat Marine Rocker On Off Control
- Unique Design: Designed to connect and disconnect a DC 12V 20A electrical circuit at will, SPST: ON-OFF control; 2 pole design (On/Off), 3rd poles with LED to be connected to earth. Fluorescent lamps will be lighted up when the switch is turned on
- Safety Protection: This truck rocker switch control uses copper-plated silver contacts, has good electrical conductivity, and uses high-quality materials and flame-retardant casing for high safety
- Widely Application: Suitable for cars, ATVs, UTVs, Wranglers, RVs, off road vehicles, trucks, boats, marines, electronics modifications, etc. Can also use these on water dispenser, running machine, electromobile and other household appliances modification
- Easy Installation: Round switches are easy to install and can be mounted directly. Our switches have keyhole slots to prevent accidental rotation. The switch wires are soldered to the terminals and the joints are neatly wrapped with shrink film. This saves time on connection and ensures a long-lasting and secure connection.
- Package Includes: 1 x Red LED Round Rocker Switch with Round Housing, 3 x Terminal Wires
Features
Nilight Round Toggle LED Switch was designed to connect and disconnect a DC12V 20A electrical circuit at will. Its reasonable size can fits in any cars and others with a 12 Volt DC source. It comes with a keyhole slot, can make it fits well and prevent unwanted rotation. You can use it when you need to convert some accessories into products that use switches.
When you installed this switch on any 12 Volt DC source, LED will light up when you turn on the switch. You can easily use this in daily life.
The Round Shell with nut makes the 12V rocker switch install or remove much easier.
Each switch will come with a set of easy disconnecting design wires , which can be easily removed by pressing the clips on the connector.
Thickened silver-plated terminals make the switch operate stably under 20A 12VDC.
Drill a 20mm diameter hole.
Use the wire connect between the device and switch.
Insert the switch into the hole.
Installed successfully.