Nilight 2 Gang Rocker Switch Panel Green Backlit with 4.8 Amp Dual USB Charger Voltmeter Waterproof 12V 24V DC Rocker Switch with Night Glow Stickers for Car Trucks Boats RVs,2 Years Warranty
Regular price $26.99
Bought to control led accessorie lights. Easy to install and they sent an assortment of both practical and humorous stickers. Have not been disappointed with nilights products yet. The built in volt meter is super useful as well.
I used this for a custom install for a light and USB phone charger for a 42 year old 4x4 truck. The switch controls the light in a camper shell with disconnect. So when I remove the shell with cutting the wires. Would recommend and will by from again.
Easy to install I just wish they came with a little longer wire on the jumpers. And could deal with some paper instructions instead of having the code to scan and looking through an entire manual on the wrong part.
High quality and the unit comes prewired. Power and power out are only wiring needed. Works great!!!
We installed this switch on our boat to use to turn on side lights at night. As you can see in the picture, it ended up getting wet during a bad storm that soaked the boat, even though it was under the carport. Still works great!!
I installed this in my camper to controll the main lights and porch light. Works great and I love that it have the voltage monitor in it.
it works as expected.
This is a great switch bank, I used it as three separate circuits so I had to remove the factory wiring. Which actually proved to cause minor problems, as terminals are not labeled for +- and switch. Once I pulled off factory wiring (which had to be done to install) rewiring was a guessing game. But it all works.
Easy to wire up, easy to install. Love the little amp meter. Blue lights are pretty bright. This is pretty well made, the mounting plate is heavy duty metal. I'm warning you however if you try to take these out of the plate they will fall apart, and they're a little challenge to put back together. You've been warned
Install was easy, very professional look.I lowered the value because I had an accessory that had a 6a12v draw and it overloaded the negative side of the switch. The switches should handle at least 10a in my opinion as there's very few things you'll power that run less than that.I've submitted a warranty request with the manufacturer regarding my unit also.