Multiple Functions: Mainly used for flag hitch mounts, stably holding and flying your proud flags while driving, in the parades. Can also be used to mount any other suitable size sticks with your wisdom, such as antenna, patio umbrella, etc for an easier life
Higher Compatibility: The flag holder is universally for a 2” hitch receiver. And suits a wide range of flagpole sizes, from 1” to 2.3” in diameter. Also, its bottom is designed to fully open to allow rest to ground and prevent water or dust from buildup
Adjustable Mounting: When sliding the flag holder to the hitch receiver, there are 3 hole positions to opt and adjust the remaining space for a possible spare tire or tailgate. The maximum space for a spare tire or tailgate is 13inch wide. You will need to measure your spare tire's thickness to confirm. Please note tailgate can only rest down halfway
Easy Installation: Just insert holder to hitch receiver, lock with hitch pin and clip; And then place pole into the holder, tighten up and fix the pole with the knob type screws; Note: Flange pipe sockets are optional to use when your pole is equal or less than 2”; Square wire lock pin is also optional for bottom close
Quality-built & All in a set: Made of heavy-duty steel and durable powder coating. And comes with all hardware for your possible needs. Includes 1x flagpole holder, 2 x types mounting screws, 1x hitch pin & hitch pin clip, 1x square wire lock pin, and 2x 2” flange pipe sockets
Hitch Receiver Size
Universally fit with 2" hitch receiver
Flag Pole Size
Suits different pole sizes from 1" to 2.3"； Add 2” flange pipe sockets When you mount a pole size equal to or less than 2"
It suits both long or short poles, you can opt to rest on the ground or not
Remain a maximum of 13" wide space for a possible spare tire. The tailgate can only rest halfway down.
Quality Built-in A Set
knob Type Bolt
Comes with a quality knob-type mounting bolt, easy to tighten up
Hitch Pin & Clip
Connect and lock with the hitch receiver
Square Wire Lock Pin
Optional to use when you want the bottom closed
Made of 2mm/0.08inch thick heavy-duty steel and durable powder coating
Universally compatible with 2" receiver on many vehicles such as SUV RV Pickup Truck Camper Trailer Jeep etc.
WARNING: Operating, servicing and maintaining a passenger vehicle or off-road vehicle can expose you to chemicals including engine exhaust, carbon monoxide, phthalates, and lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. To minimize exposure, avoid breathing exhaust, do not idle the engine except as necessary, service your vehicle in a well-ventilated area and wear gloves or wash your hands frequently when servicing your vehicle. For more information go to www.P65Warnings.ca.gov/passenger-vehicle
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov